Rancho Mirage, CA

client will call us back when back n town,,,,,need to go back to see where and how we can run electrical

Today is Daniel calling preventative maintenance consisted of one American standard gold system. I first begin with ensuring that the ecobee thermostat is properly calling for cooling and turning the unit on with no errors occurring period following with the Accu clean system, getting thoroughly washed down to remove all dirt debris and make sure that it thoroughly dried out before putting it back to ensure that proper air fluid is able to circulate through the home at minimal resistance. I then cleared the condensation line thoroughly to ensure that all of the water is able to thoroughly drain with no obstructions. All of the cooling sequence of operations are successfully checking out for this American Standard goal system verifying there is a proper 20° split between the liquid line and the suction line which verifies that the home is being called officially to the desired temperature. The amps on the system are safely checking out as well to ensure controlled voltage is being used

Today’s annual cooling preventative maintenance consisted of two systems. I first ensure that all three filters in the home have been replaced, ensuring that there is proper air fluid able to circulate back to the unit and minimal resistance. I then ensure that both of the Honeywell thermostats are properly calling for cooling and turning the units on with no errors. I then followed with clearing the condensation line thoroughly to ensure that it is properly draining at this time of service. All of the cooling sequence of operations are successfully checking out for both of the systems verifying there’s a proper 20° split being provided between the liquid line and the suction line which ensures that the home is being cooled efficiently to the desired temperature following with each amps on the system checking out safely in the correct range verifying a controlled voltage is being used following with each capacitor also safely testing out and then thoroughly washed the coils down of eac

🧊❄️ 2021 Dikin split heat / full inverter technology Semi annual cooling service Replaced filters throughout the house/ceiling mounted Cycle equipment followed, cooling sequence of operation, checked fan motor, compressor, amps and voltage Cleared condensation line from outside Thermostat checked out OK Secured and clean electrical connections at condenser Rinse condenser coil ✅✅ Cooling equipment checked out operation operational at this visit

Wash condenser check cooling and electrical components everything is working properly in cooling

After Diagnostic found grounded compressor sent estimates for warranty compressor and new systems

Today’s fist time annual cooling maintenance consisted of two American standard gold systems and one other system. I first began with ensuring all three thermostats are properly calling for cooling and turning the units on with no errors occurring, following with all three filters providing proper air flow at minimal restrictions. I also cleared the condensation lines thoroughly to ensure proper drainage is occurring for the systems. All of the cooling sequence of operations are successfully checking out for all three units, verifying there’s a proper 20 degree split for all three systems between the liquid line and the suction lines, this verifies that the home is being cooled efficiently to the desired temperature. The amps on each systems are safely checking out in the correct range to ensure a controlled voltage is being used correctly. Following with both surge protections also being good with a green light still. Overall all three of these units are operating to the manufacturer

Check both systems capacitors and compressor saver are within range everything else is working properly

book estimate

Arrived to diagnose a switch that was not functioning properly following a prior visit. Upon opening the switch box, I observed that one of the wires was not fully secured in the wire nut. After securing the wire properly, the light fixture resumed normal operation.